This unit is also available for sale at http://clearskycamera.com
The unit has four main hardware components and a printable case. Links for electronics and 3D printed parts are provided below.
Step 1: Face the camera up and the bracket flat-side down and slide the camera in to the side of the bracket.
Step 2: Place the shield over the camera and snap it in to the bracket.
Step 3: Thread the camera's ribbon cable through the lid so that it comes out the side with four pinholes and snap the combined pieces on to the lid.
Step 4: Place the Raspberry Pi in to the base and plug in the ribbon cable to the DCI port next to the audio jack.
Step 5: Line up the lid with the base and gently press them together, folding the ribbon cable as needed.
Build a Raspberry Pi DVR with noise cancelling motion detection